12
1
7
4
10
15
18
2
8
13
5
11
16
3
9
14
6
12
17
BASIC OPERATIONS
4
■ Setting the Call channel
By default, a Call channel is set in each Channel Group.
You can set your most often-used channel as your Call channel in each Channel Group
for quick recall.
1. Open the “CALL CHANNEL” screen.
[MENU] > Settings > Radio > Call Channel
2. Push [▲] or [▼], or rotate [DIAL] to select the
channel.
3. Push [ENT] or [DIAL] to set the selected
channel as the Call channel.
4. Push [MENU] to exit the Menu screen.
■ AquaQuake Water Draining function
Water in the speaker grill may muffl e the sound coming from the speaker. The
AquaQuake Water Draining function removes water from the speaker grill by vibrating the
speaker cone.
CAUTION: DO NOT use the AquaQuake Water Draining function when an external
speaker is connected.
1. Push [◄] or [►] to display
.
2. Hold down
to turn ON the function.
• A low frequency vibration beep sounds to drain
the water, regardless of the volume level setting.
L This function is activated for a maximum of 10
seconds, even if you continue to hold down
.
3. Release to turn OFF the function.
■ Editing a channel name
You can edit the name of each operating channel and weather channel, using numbers,
uppercase letters, symbols, and a space. This enables easy recognition of the channels
or stations. All VHF marine channels are set with default names.
1. Push [▲] or [▼], or rotate [DIAL] to select the channel to edit.
2. Push [◄] or [►] to display
.
L You cannot edit a channel name during
Dualwatch, Tri-watch, or a scan.
3. Push .
• The “CHANNEL NAME” screen is displayed.
4. Edit the channel name.
L Select to enter numbers, and to
enter symbols.
5. Select , and then push [ENT] or [DIAL]
to save the edited name and return to the operating screen.
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com
To Next Page
Loading...
