EasyManuals Logo

Icom ID-800H Operating Guide

Icom ID-800H
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Icom ID800H MiniOperating Guide by W5JCK, September 2007 Page 1 of 6
Icom ID-800H VHF/UHF Radio
MiniOperating Guide by W5JCK
1
[SETLOCK] Set, Lock Switch
Press to enter Set mode.
Press and hold for 1 sec. to switch the
Lock function On or Off.
2
[DIAL] Tuning Dial
Turn to select operating frequency, memory
channel, setting for Set mode item, or
scanning direction.
3
[VOL] Volume Control
Turn to adjust audio.
4
[PWR] Power Switch
Press and hold 1 sec. to turn power On/Off.
5
Microphone Connector
Connects the HM-133 microphone.
6
[SQL] Squelch Control
Turn to adjust squelch level.
7
[MONI●DTMF] Monitor, DTMF
Press to switch the Monitor funct. On/Off.
● During analog operation, press and hold
for 1 second to turn DTMF memory
encoder On or Off.
● During digital operation, press and hold to
turn the EMR function On or Off.
8
[LOW●DUP] Output Power, Duplex Switch
● Press to change the power output level.
● Press and hold for 1 sec. to select
between DUP-, DUP+, and Simplex
operation.
9
[TONE●T-SCAN] Tone, Tone Scan Switch
During analog operation, press to select a
Tone function.
● During digital operation, press to select a
digital Squelch function.
● During digital operation, press and hold to
turn the Break-in function On or Off.
10
[M/CALL●PRIO] Memory/Call, Priority Sw.
● Press to select between memory, Call, and
Weather Channel modes.
● Press and hold for 1 sec. to start the
Priority Watch operation.
11
[V/MHz●SCAN] VFO/MHz Tuning, Scan Sw.
● Press to select between VFO mode and 1
MHz Tuning mode.
● Press and hold 1 sec. to start/stop scan.
12
[BANDMODE] Band Switch
During VFO op., press to select the
operating frequency.
● During Call Channel op., press to select
between call channels 1 or 2.
● During Memory Channel op., press to
select memory bank condition.
● Press and hold for 1 sec. then turn to
select operating mode.
13
[S.MW●MW] Memory Write Switch
● Press to select a memory channel for
programming.
● Press and hold for 1 sec. to program a
memory channel.

Other manuals for Icom ID-800H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom ID-800H and is the answer not in the manual?

Icom ID-800H Specifications

General IconGeneral
BrandIcom
ModelID-800H
CategoryTransceiver
LanguageEnglish

Related product manuals