Icom iF4029SDR

15
5
RINGER FUNCTION (Analog mode operation only)
n Call-Ring operation
q Set the same operating channel and CTCSS tone code for
all of your group transceivers.
w
Push and hold
(S-Ring/Ringer) to send the pre-se
-
lected ring tone to your group members.
• “ ” and “ ” appears.
• The ring tone* is emitted while
(S-Ring/Ringer) is pushed
and held.
• The same ring tone comes from your group station’s speaker.
AppearsAppears
While transmitting
* The Call-Ring emission type can be selected in Set mode.
(p. 27)
n Auto channel function
The auto channel function automatically searches a clear
channel during scan when (S-Ring/Ringer) is pushed.
Then, the ringer tone is transmitted for a specified period in
the founded clear channel. Another station during scanning
may answer the call in the clear channel if it receives the
ringer signal.
q Push [Auto Ch] to start scan.
• The selected scan type and scan list are available. (pgs. 10, 12)
w To call a waiting station, push
(S-Ring/Ringer) for 1 sec.
to transmit a ringer tone.
• The auto channel function automatically searches a clear chan-
nel. After a clear channel found, a ringer tone is transmitted.
• To call a waiting station by voice, push [PTT] until beep tones
sound (for longer than the ringer time), then speak into the mi-
crophone.
e The auto channel function restarts 30 sec. later after a
busy signal disappears and in which no operation is per
-
formed while the auto channel function is in use.
r Push [Auto Ch] to cancel the function.