Icom iF4029SDR

25
8
SET MODE
n Set mode programming
Set mode is used to change the conditions of the transceiver’s
functions: Backlight, Beep, Beep level, Squelch level*
1
, Mic
gain, Battery voltage, Signal monitor*
1
, Ringer*
1
, Ringer2*
2
,
Ringer timer*
1
, Ringer2 level*
2
, Code type*
1
and Power save.
Available functions may differ depending on how they are
set by the dealer.
*
1
Appears during in Analog mode operation.
*
2
Appears during in Digital mode operation.
q Turn power OFF.
w Push and hold [User Set Mode] to enter the set mode.
e Push [User Set Mode] several times to select the desired
item.
r Push [Side2] (CH Up) or [Side3] (CH Down) to select the
desired condition of the item.
t Push and hold [User Set Mode] to return to the normal
operation mode.
• Backlight
• Beep tone level
• Squelch level*
1
• Mic gain level
• Battery voltage indication
• Signal monitor function*
1
• Ringer type*
1
• Ringer2 type*
2
• Ringer timer*
1
• Ringer2 output level*
2
• Power save activity
• Beep tone
*
1
Appears during in Analog mode operation.
*
2
Appears during in Digital mode operation.
• Tone code indication
type*
1
: Push [User Set Mode]
ï Set mode construction