Icom UT-109 - Appendix -2; Cloning

APPENDIX -2; CLONING -1
DD
SCRAMBLER ON/OFF/INH
Turns the scrambler function "ON" or "OFF" as a initial
setting. This item can also be turned "ON" or "OFF"
with a program function switch when the function is as-
signed to a switch.
"INH": This means the scrambler function selection is
inhibited.
Optional UT-109 or UT-110 Voice scrambler unit is re-
quired.
DD
Scrambler code
Set the scrambler code number.
Selectable value;
UT-109: 1 to 32
UT-110: 1 to 255
*Set the scrambler group code in the Common screen
in advance. (UT-110 only)
DD
SCRAMBLER GROUP CODE (UT-110 only)
Set the scrambler group code.
➥ Selectable value; 1 to 4.
Optional scrambler unit (UT-110) is required.
NOTE: This setting is invalid for UT-109.
DD
SCRAMBLER TYPE (UT-110 only)
Set the UT-110 Rolling type scrambler as UT-109
Non-rolling type. As UT-110 and UT-109 have differ-
ent code settings, they are not compatible.
By selecting Non-rolling type in this item, you can use
UT-110 as UT-109.
➥ Selectable value;
Rolling type (UT-110 normal)
Non-rolling type (UT-110 functions as UT-109)
NOTE: This setting is invalid for UT-109.
NOTE: The following setting will be invalid: Scrambler
Group Code
DD
SYNCHRONOUS CAPTURE (UT-110 only)
"Synchronous capture mode" is useful when commu-
nicating through a repeater. However, because of
voice components, the transceiver can not maintain
synchronous mode in rare cases.
Normally it is best to set this item to "Standard".
➥ Selectable value;
Standard (Normal operation)
Continuous (repeater operation)
DD
TONE START TIMING (UT-110 only)
Tone start timing selects the synchronous tone signal
transmit delay time.
Set the delay time when the other party's transceiver
has power save mode.
➥ Selectable value; OFF(default)
0.300s, 0.600s, 1.100s
M Memory CH screen
MM
Common 2 screen
- 5 -