ICON PRO-FORM PRO C22 - Page 33

33
Note: Specifi cations are subject to change without notice. For information about ordering replacement parts, see
the back cover of this manual. *These parts are not illustrated.
Key No. Qty. Description Key No. Qty. Description
91 1 Mount Wire
92 2 M8 Washer
93 1 M8 x 80mm Bolt
94 2 Outer Pivot Disc
95 2 Inner Pivot Disc
96 2 Upper/Lower Pivot Disc
97 1 Center Pivot Disc
98 1 Wire Protector
99 1 Pivot Spacer
100 1 Brake Shaft End
101 1 Hairpin Cotter Pin
102 1 Brake Washer
* – Assembly Tool
* – User’s Manual