ICON MOTOSPORTS VARIANT MANUAL
3
ICON MOTOSPORTS VARIANT HELMET
4
CONSTRUCTION
The Variant is engineered to the ICON WORLD STANDARD, which meets or exceeds DOT FMVSS 218 (US), ECE 22-05 (EUROPE), SAI
AS1698 (AUSTRALIA) & SG (JAPAN) Helmet Safety Standards. Over 50 countries offi cially recognize these extensive head protection
standards. Refer to the diagram below to familiarize yourself with specifi c names and terms used on the Variant helmet before
attempting to repair or replace parts on the helmet.
MAKE NO MODIFICATIONS. To maintain the full effectiveness of this helmet, there should be no alteration to the structure of this helmet
or its component parts. Paints and adhesives may damage and render your helmet ineffective, without the damage visible to the user.
Using industry-leading pneumatic molding processes, the
Variant’s Fiberglass, Dyneema and Carbon Fiber composite
shell sports a proprietary interlacing system crafted to
emphasize superior strength along with centralized
mass and minimal weight.
FIG.1
::
OUTER SHELL
The Variant’s dual-density EPS liner is actually two
separate expanded polystyrene liners engineered to offer
maximum impact absorption and force dissipation.
Additionally, both liners are channeled with an extensive
series of directional air ducts to distribute airflow from the
outer ventilation system.
FIG.2
::
EPS
::
EXPANDED POLYSTYRENE LINER
To Next Page
Loading...
Need help?
General
