Iconic VF1 - MAINTENANCE AND CLEANING; Fuse Replacement Procedure; SPECIAL STORING CONDITIONS

12
7 - MAINTENANCE AND CLEANING
Always keep the Iconic VF1 clean and protected from moisture, specially the resistance in the heating unit.
To clean the cabinet, use only water, wet cloth and use neutral detergent. The heating element is a component that
requires some attention, it should not receive moisture while heated and should not be touched by tools or metallic
objects.
If you need to replace the element, it should be done by authorised personnel.
In case the power cord is damaged, it should be replaced by another with the same characteristics and certications.
The machine upright does not require lubrication, keep it always clean and free from dust or residues.
7.1 - Fuse Replacement
7.1.1 Disconnect the power supply cord from the outlet and input connector before replacing the fuse.
7.1.2 Insert a small screwdriver in the hole in the upper part of the fuse-holder cover located in the input connector (AC)
forcing it out until the assembly gets loose.
7.1.3 Pull the fuse-holder assembly out to the end and watch for the existence of two (2) fuses tted in the support.
7.1.4 The fuse that is near the internal part of the compartment is the faulty fuse that must be replaced. The other one
(near the compartment cover) is the spare fuse that will be used to replace the faulty fuse.
7.1.5 Insert the assembly with the replaced fuse in the compartment again and press them until is ts completely.
7.1.6 Turn the machine on to check as to the correct functioning. In case the fuse shows problems again, forward the
equipment to the Authorized Service to verify the likely cause of the problem and solve it.
7.1.7 Contact DB Orthodontics for replacement 10Amp fuses.
8 - SPECIAL STORING CONDITIONS
In case the machine needs to stay idle for long periods of time, we recommend to store it in its original packaging in a
dry, airy, free of vibration location and sheltered from sunlight.