Iconix FX21 - DRAFTING (SORTING BY WEIGHT); Setting Draft Limits for Sorting

Page 6 FX21 User Manual V5.01+ 14Dec07
DRAFTING (SORTING BY WEIGHT)
Draft limits may be set to allow sorting of animals into weight ranges. Both 2-way and 3-
way drafting are possible.
NO DRAFTING
Set draft limits Draft 1 and Draft 2 to 0.0
2 WAY DRAFTING
Set one draft limit to the required weight and set the other to 0.0
The display will show I (high) or M (low) alongside the weight.
3 WAY DRAFTING
Set the draft limits to the required weights.
The display will show I (high), D (centre) or M (low) alongside the weight.
DRAFT LIMIT SETTING
Press DRAFT LIMITS for esBGu/2
Then enter the weight using the numeric keypad.
Press DRAFT LIMITS again for esBGu/3
Then enter the weight using the numeric keypad, if required.
Press DRAFT LIMITS again to return to the weighing mode.
Auto-Drafting Option: When the Auto-Drafting option is enabled, there are two
additional settings available when the DRAFT LIMITS key is pressed. See the section
AUTO-DRAFTING OPTION below.
DUPLICATE TAG NUMBERS
If a tag number is repeated, when WEIGH is pressed, ’eVQM’ is alternately
displayed with the tag number.
If the number is correct, press WEIGH again to continue (noting that the previous use
of that number is probably incorrect).
If incorrect, use DELETE one or more times, then re-enter.
Zero is not considered to be a valid tag number, so repeated use is permitted.
The FX21 is factory set with this feature enabled. See Set-Up section for details on
disabling.