Page 8 FX21 User Manual V5.01+ 14Dec07
Note: ‘HsQ 1’ may not be used for storing records in a weighing session. If an
attempt is made to do so, the message ’op/Tups’ is displayed briefly.
CLEARING RECORDS
To clear all records in the currently selected group:
Ensure that the correct group for deletion is currently selected, by using the key
sequence: *GROUP
Display any statistics function (see DISPLAYING STATISTICS below), then while
any of the statistics are flashing on the display, press the DELETE key.
The operator is then prompted with the message ’TvsF @’.
Press DELETE again within 2 seconds to confirm. ’eFMfuf’ is displayed if the
file has been cleared. If DELETE is not pressed within 2 seconds,
’op eFM’ is
displayed.
STATISTICS
Statistics apply to all records in the currently selected group.
In the case of Group 0, statistics apply to all records in memory, regardless of which
groups they are located in.
DISPLAYING STATISTICS
Pressing the key, the display shows ’TFMFDu’.
Press the corresponding number key to select from:
*WGT STATS, *AVG SCORE, *DRAFT NO’s, *DRAFT WGTS or *DRAFT TOT.
While the statistics are calculated, ‘cVTZ .( is displayed briefly.
For example :
Press *WGT STATS :
op. = number of animals weighed is displayed.
Press *WGT STATS again :
BvH = average weight is displayed.
Press *WGT STATS again : upuBM = total weight of animals is displayed.
Press *WGT STATS again to return to the normal weighing mode (’Foe’ is
displayed) OR press any other statistics key (eg *DRAFT NO’s) to begin displaying a
different set of statistics :
*DRAFT NO’s : I = number of animals in High Group
D = number of animals in Centre Group
M = number of animals in Low Group
To Next Page
Loading...
