Copyright © 2014 ICP DAS Co., Ltd. All Rights Reserved. ∗ E-mail: service@icpdas.com - 21 -
NOTE
The IP/Subnet mask/Gateway modified in a MDC-700 can be reset to factory defaults by shorting
the RESET pin to GND pin over 3 seconds. The LED display will show “RESET” as below and the IP
address set previously will be cleared and returned to the factory default.
STEP 7: After the success message is displayed, restore the IP address of your computer,
log in the MDC again via its new IP address.
To Next Page
Loading...
