Copyright © 2014 ICP DAS Co., Ltd. All Rights Reserved. ∗ E-mail: service@icpdas.com - 20 -
STEP 5: Enter your username and password to log in to the MDC module.
STEP 6: Choose a valid IP address of the network for your MDC-700 module
Scroll down to Ethernet Configuration section, input the IP/Subnet mask and Gateway
addresses, and then click “Apply”. Make sure that the IP address you pick is not currently in
use by another device on the network.
.
1. Enter your username
2. Enter your password
3. Click LOGIN
To Next Page
Loading...
