ICP OLR105A12D - Page 7

THREAD SPIN SLEEVE
ONTO OUTER SLEEVE
CUT OUTER SLEEVE
BACK 5”
THREAD SPIN SLEEVE BACK 10” CUT STAINLESS STEEL
CORE BACK BY 3”
FIGURE 1.3 FIGURE 1.4
FIGURE 1.1 FIGURE 1.2
DRIVE THREE STAINLESS STEEL
SCREWS, STARTING NEAR TOP
FIGURE 1.5 FIGURE 1.6
8
INSERT STAINLESS STEEL
CORE ONTO BREECH TUBE