To Next PageTo Next Page
Need help?Do you have a question about the ICP PHX336000K00A1 and is the answer not in the manual?
Provides detailed dimensional specifications and diagrams for the "B" chassis heat pump units.
Details dimensions and requirements for roof curb installations for "B" chassis units.
Covers essential safety precautions, unit placement, access panel locations, and minimum clearances for safe operation.
Outlines procedures for unit installation, including ground level, rooftop, hoisting, downflow conversion, and condensate drain setup.
Specifies requirements for disconnect switches and proper ground connections to ensure electrical safety.
Guides for making line voltage and low voltage/thermostat wiring connections within the unit.
Details guidelines for ductwork sizing, insulation, connections, and ensuring proper airflow.
Explains the necessity of filters and lists minimum recommended filter sizes for various unit models.
Presents a table of blower speeds and corresponding air delivery (CFM) at various static pressures.
Illustrates blower speed tap settings for low, rated, and high capacity airflow for different models.
Describes how to adjust blower speeds for heating and cooling, including specific wiring instructions.
Lists essential checks to perform before powering on the unit for initial startup.
Details the operational sequence for both cooling and heating modes, including stage changes and fan control.
Explains features like the scroll recycle delay timer, continuous fan operation, and defrost mode sequences.
Outlines routine monthly inspections, including checking and replacing air filters.
Details monthly checks for the cooling season, focusing on the condenser coil and condensate drain.
Covers comprehensive annual inspections, including fan motors, blower access, and cleaning procedures.
Presents the schematic wiring diagram for the 2 to 5 ton PHX3 series heat pumps.
General