13
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
SAFETY
CAUTION
A potentially hazardous situation exists which, if not avoided, may
result in minor or moderate injury or property damage.
• Always turn a concrete chain saw OFF when performing
maintenance on the saw including chain tensioning.
• Never use equipment that is not functioning properly.
• Have the saw repaired only by qualified service personnel.
• Turn engine OFF before refueling. Keep away from open flame.
Always provide adequate ventilation when handling fuel. Move
saw at least 10 feet (3 m) away from refueling area before
starting.
• SealPro
®
diamond chains require a minimum water pressure of
20 psi (1.5 bar). Insufficient water supply may result in excessive
wear to the chain, which can lead to loss of strength and chain
breakage, and/or damage to the guidebar nose sprocket.
• Never start saw unless the bar, chain and side cover are
properly installed.
THE FOLLOWING SYMBOL APPLIES TO ALL THE ITEMS LISTED ON
THIS PAGE
To Next Page
Loading...
