31
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
Follow these simple maintenance guidelines
and your saw will continue running at its very best.
AFTER EACH USE
1. Rinse the saw, guidebar and diamond chain with water.
2. Inspect and tighten all fasteners as necessary.
3. Inspect, flush and grease the chain tensioner.
4. Inspect drive sprocket for wear. Replace if tooth tips are pointed, or if
groove cuts through top of tooth.
5. Check clutch cup needle bearing for wear. Ensure clutch cup spins
freely and without excessive play.
6. Check starter cord for wear or damage. Replace as necessary.
7. Inspect air filter. Replace filter if dirty.
8. Spray saw, guidebar, and chain with lightweight oil.
9. Spray lightweight oil into the air intake slots on the starter housing to
keep starter pawls from sticking.
AFTER 10 HOURS OF USE
1. Remove the starter cover and clean the flywheel fins and the starter
pawls with a wire brush, then grease the starter pawls.
2. Remove the spark plug and clean with a wire brush. Check the
electrode gap. The correct gap is 0.020 inches (0.5 mm).
3. Grease the clutch cup needle bearing,
AFTER 40 HOURS OF USE
1. Change the spark plug. Adjust the electrode to 0.020 in (0.5 mm).
2. Check the fuel filter located inside the fuel tank. Clean or replace if
clogged.
MAINTENANCE
To Next Page
Loading...
