30
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
SYSTEM CLEAN-UP
• After cutting, run the saw for at least 15 seconds with the water on to
flush slurry and debris from chain, bar and drive sprocket.
• Wash concrete slurry from saw assembly.
• Avoid getting any water in the carburetor or exhaust system. If water
enters exhaust port, point the bar tip down and pull the starter handle
several times to expel water from muffler.
• Remove bar and chain. Flush out the chain tensioner and side cover
with water. Lubricate tensioner with grease.
• After cleaning the saw, spray the entire saw body, chain, bar, and
drive sprocket with lightweight oil. Using lightweight oil on the saw will
minimize rust and help reduce slurry build up.
CUTTING DUCTILE IRON PIPE WITH THE POWERGRIT
®
UTILITY SAW
CHAIN
NEVER cut ductile iron pipe with the saw unless using PowerGrit Utility Saw
Chain. The following are safety precautions that should always be followed
when using PowerGrit.
• Before cutting, make sure the pipe is in a safe condition to be cut.
Support the work piece in such a way that the cut remains open
during the cutting operation and when the cut is finished. Pinching
the chain during the cut could cause chain breakage and could
result in death or serious injury to the operator.
WARNING
OPERATION
To Next Page
Loading...
