ICS 695GC - Engine Starting Procedures

8
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
QUICK START GUIDE
WARNING
Neverstartthesawwithouttheguidebar,diamondchain
andsidecoverproperlyinstalled.Failuretodosomay
resultinseriousinjury.
CAUTION
IMPORTANT
Alwaysmovethesawatleast10feet(3m)awayfromthe
fuelingareabeforestarting.
Placethesawonclearground.Ensurethatsecurefooting
isestablishedandchainisnotcontactinganyobjects.
STARTING THE SAW
• Pullthechokeleverout,whichalso
setsthethrottlelock.
• Depressprimerbulbapproximately
5–10times.
1
2
ENGINEBREAK-IN
•Itisveryimportanttobreak-inanewengineto“seat”allmovingparts,especially
thepistonrings.
•Tobreak-intheengine,runonefulltankof50:1(2%)fuelatidle,cyclingthethrottle
every5to10minutestopreventloading.
•Failuretobreak-inanenginemayresultinpistonseizure.