ICS 695GC - Page 9

9
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
QUICK START GUIDE
• Pushindecompressionvalve.
3
• Openthewatervalve1/4turn.
• Pushchokeleverin.
• Placethesawonstablegroundmaking
surethechainisfreeofanyobstructions.
• Placefootonthebaseoftherearhandle,
andplaceonehandonfronthandle.With
oppositehand,slowlypullstarterhandle
untilthestarterpawlsengage.
• Pullthestartercord(hard, fast, short
pulls)untilengineinitiallyresor“pops”.
Couldbeasmanyas10–15pulls.
• Pullthestartercorduntilenginestarts–
shouldbe1to2pulls.
• Releasethethrottlelockbymomentarily
squeezingonthethrottletrigger.
• Whentheenginestarts,allowtheengine
toidlebriey.Squeezethethrottletrigger
severaltimestohelpwarmuptheengine.
• Openthewatervalvecompletely.
4
5
6
7
FIRES
ASMANYAS15PULLS
5TO7PULLS
STARTING THE SAW
(continued)