To Next PageTo Next PageHow to fix no central heating with Ideal Boilers LOGIC SYSTEM S15?
If your Ideal Boilers boiler isn't providing central heating, try these steps: * Check that the boiler has power and the control knob is in the 'N' position. * Confirm the programmer (external to the boiler) is in the 'ON' position and the room thermostat is turned up. * Adjust the time settings on the programmer if they are not set as you require.
Why is there no hot water from my Ideal Boilers boiler?
If you're not getting any hot water from your Ideal Boilers boiler, here are a few things to check: * Make sure the boiler is getting power and the control knob is in the 'ON' position. * Ensure the programmer (external to the boiler) is in the 'ON' position and the hot water cylinder thermostat is turned up. * Verify that the time settings on the programmer are correct and adjust them if needed.
Current Gas Safety (Installation & Use) Regulations or rules in force for boiler installation.
Appliance must be earthed; Supply: 230 V ~ 50 Hz. Fusing should be 3A.
Crucial warnings on casing, storage, faults, and tampering for safe appliance use.
Legend for boiler controls including temperature, mode, status indicators, and buttons.
Step-by-step instructions for initiating the boiler's ignition sequence.
Guidance on adjusting the central heating radiator temperature via the control knob.
Tips for optimizing boiler efficiency and reducing gas consumption.
Explanation of how the weather compensation feature controls room temperature.
Measures to prevent the boiler freezing during cold weather.
Procedure for restarting the boiler after a fault condition.
Instruction on how to remove all power to the boiler.
Instructions for safely thawing a frozen condensate pipe.
Advice on preventing the condensate pipe from freezing.
Steps to follow when system water pressure falls below the recommended level.
Information on the boiler pump's self-check function.
Required clearances around the boiler for installation and servicing.
Emergency procedure to follow if a gas leak is suspected.
Guidance on cleaning the boiler casing with a dry or damp cloth.
Recommendation for annual servicing by a qualified engineer.
Guide to identifying and resolving common heating or hot water issues.
General| Output | 15 kW |
|---|---|
| Dimensions (H x W x D) | 700 x 395 x 278 mm |
| Mounting | Wall-mounted |
| Max Working Pressure | 3 bar |
| Central Heating Flow Temperature Range | 30 - 80 °C |
| Fuel Type | Natural Gas |
| Domestic Hot Water Output | Not applicable |
| ErP Water Heating Efficiency | Not applicable |
