To Next PageTo Next Page
Need help?Do you have a question about the IDEAL Esprit eco 30 and is the answer not in the manual?
General| Output | 30 kW |
|---|---|
| Mounting | Wall-mounted |
| ERP Heating Efficiency Class | A |
| ERP Water Heating Efficiency Class | A |
| Domestic Hot Water Output | 30 kW |
| Max. working pressure | 3 bar |
| Type | Combi |
| Fuel Type | Natural Gas |
| Dimensions | 700mm x 395mm x 278mm |
| Central Heating Output | 24.2 kW |
Covers essential safety regulations for boiler installation and use.
Details legal requirements for installation by qualified engineers.
Specifies voltage, frequency, and fusing for the appliance.
Defines required space around the boiler for safe operation and servicing.
Specifies reduced bottom clearance for access to pressure gauge.
Step-by-step guide for igniting the boiler, including checks.
Instructions for resetting the boiler if it fails to operate.
How to set the boiler for central heating and hot water demand.
Details on controlling and adjusting hot water temperature.
Information on setting and adjusting radiator water temperature.
Using weather compensation for room temperature control.
Instructions for turning off and restarting the boiler.
Details on boiler protection against freezing and overheating.
Describes the fault code for flame failure.
Identifies and explains the purpose of each boiler control knob.
Explains how to identify and address low system pressure.
Instructions for dealing with frozen condensate pipes.
Recommendations for cold weather operation.
Action to take in case of a suspected gas leak.
Guidance on how to clean the boiler safely.
Requirement for yearly servicing by a qualified engineer.
Guide to setting heating and hot water schedules.
How to manually set the timer to permanently on or off.
Checks and steps for resolving no hot water problems.
Checks and steps for resolving no central heating problems.
Troubleshooting steps for complete heating and hot water failure.
Boiler status when awaiting demand.
Boiler status when central heating demand is met.
Boiler status when hot water demand is met.
Boiler status during central heating operation.
Boiler status during hot water operation.
Boiler status during pre-heating phase.
Boiler status when operating in frost protection.
Action for boiler fault code F6.
Action for boiler fault code F7.
Action for boiler fault code F9.
Action for boiler fault code L5.
Action for boiler fault code L6.
Action for boiler fault code C0.
Action for boiler fault code C2.
Action for boiler fault code F1.
Action for boiler fault code L1.
Action for boiler fault code F2.
Action for boiler fault code L2.
Action for boiler fault code F3.
Action for boiler fault code F4.
Action for boiler fault code F5.
