IDEAL Halo Combi RF

E. PAIRING OF THE HALO
The Halo unit now needs to be paired with the Smart Interface installed in the boiler.
Ensure the Halo Smart Interface is in pairing mode and the Zigbee LED is flashing red.
1. After the batteries are inserted, the Halo will
power up automatically.
2. The device will prompt pairing with the Halo
Smart Interface using an easy step-by-step
process.
3. Simply follow the on screen guide to select
the type of boiler and number of zones. In
this case select Combi boiler and single zone.
4. The Halo screen will show “Pairing in
Progress”, then “Synchronisation in Progress”
and then “Pairing Complete” when the Halo
has successfully connected to the Smart
Interface.
5. The device will automatically prompt set up
of the time and date.
6. There is the opportunity to add an installer
contact phone number into the device at this
stage, if not changed this will default to the
Ideal Boilers Customer Service number.
7. The home screen will be displayed showing
the current and target temperature and the
temperature bar. The Zigbee communication
icon will also be visible on the display.
8. Press and hold the Pair button on the Halo
Smart Interface until the Zigbee LED goes
from flashing red to solid green.
Pairing to smart interface in
progress, this could take a little
while
12 91
menu
Sat, 17 Nov
mode
auto
9:33pm
0
5
target temp
until 10:00pm
current room
temp
12 91
menu
Sat, 17 Nov
mode
auto
9:33pm
0
5
target temp
until 10:00pm
current room
temp
Zigbee icon