IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User’s guide DLC4000/DLC8000 - Doc. V2.1 - Firmware V3.1
1
CM
1 2
2 3 4 5 6 7 8 9 10
3 4 5 6 7 8 9 10
CM
Page 7
50,00 mm
4,00 mm
&
CHECK THE SCALE (X & Y)
AFTER PRINTING
ATTENTION
THE DRILLING TEMPLATES WERE CREATED BY THE EDITOR USING A 1:1 SCALE. FOR THIS
REASON, SOME PRINTERS OR PRINTING SOFTWARE MAY CAUSE DISTORTIONS ON PRINTING.
YOU SHOULD VERIFY THE SCALE BEFORE USING THE TEMPLATES BELOW.
6.1. Controlling the Template Scale after Printing
The rulers below allow you to control the scale on the two axes :
6.2. Console Mounting Foot
6.
Drilling Templates
To Next Page
Loading...
