iDPRT SP900 - Interface Cable Connection; Cash Drawer Connection; Print Test; Print Self-Test

SP900 User Manual
23
4.4 Interface Cable Connection
1. Make sure the printer's power switch is turned off.
2. Put the interface cable into the matched interface.
3. Connect the other end of the interface cable to the host.
4.5 Cash Drawer Connection
1. Make sure the printer's power switch is turned off;
2. Connect the cash drawer cable into the cash drawer interface on the rear side of the printer.
Warning:
Cash drawer interface can only be connected to a voltage of 24V cash drawer device (can’t
connect to the phone line, etc.)
4.6 Print Test
4.6.1 Print Self-Test
The self-test checks the printer’s current settings, status and whether the printer has any problem.
1. Make sure the power is connecting and paper is loading properly.
2. Make sure the printer is off and printer cover closes properly.
3. Press the paper feed button and power button simultaneously turns the printer on.
4.6.2 Printing of Windows Driver Program
1. Install the Windows Driver program. (Please refer to the Windows Driver Manual)
2. Please set the “Interface” as the type you use.
3. Use the Windows Driver Program to print out the “Print Test Page”.