25
IDS 1632 User Manual 700-256-01I Issued March 2009
21. Remote Telephone Access
Please note that this section only applies if programmed by your installer.
The IDS 1632 Alarm Panel has a secure, remote telephone interface that allows a user to arm/disarm, to
bypass/un-bypass zones and to set programmable outputs via a phone line. A user accesses the remote
dial-in interface by dialling the Alarm Panel using a DTMF phone.
To access the remote dial-in interface, dial the Alarm Panel and wait the number of rings programmed
(the default number of rings being15). If the fax defeat function has been enabled, dial the panel and
hang up after one ring. Dial in again within 1 minute, the panel will pickup immediately and transmit
handshake tones consisting of a high pitch tone for two seconds followed by a lower pitch tone for one
second.
Within twenty seconds of the panel transmitting the handshake tones, enter a valid user code
on the DTMF enabled phone. If a user code is not entered or if the user code is invalid - the panel will
release the line. If the user code is valid and telephone access has been enabled, the panel will give a
single confirmation beep indicating that the user has gained access to the remote interface. If no key-
presses are detected for twenty seconds once access has been gained to the remote interface the panel
will release the line.
Should the panel be programmed to report to your cellular telephone, entering the user code in the delay
between beeps will also allow access to the remote telephone interface.
The addition of a Voice Module to your Alarm Panel will provide a voice prompted menu as well as voiced
reporting over the telephone. (Provided your panel connects to phone lines, or has GPRS Module fitted)
To Next Page
Loading...
Need help?
General
