21
IDS 805 Installer Manual 700-266-02H Issued September 2009
LOCATION 19 AC Fail and Restore Time
2 3 minutes 10 11 minutes
3 4 minutes 11 12 minutes
4 5 minutes 12 13 minutes
5 6 minutes 13 14 minutes
6 7 minutes 14 15 minutes
7 8 minutes 15 16 minutes
If the AC
power should fail, the panel will wait for this period of time before reporting the mains failure to
the base station or logging the event to the event log. If the AC
power is restored after the time out period
has ended the same time out period will apply before the restoral event is reported and logged.
If the AC
power is restored during the delay period neither the power failure, nor the power restoral will be
reported or logged to the event log. This delay eliminates unnecessary reporting if the AC
power to the
panel is accidentally removed for a short period (provided the backup battery is in good condition, short
AC
power failures will not affect the functioning of the alarm system).
Select the appropriate value from the table above.
LOCATION 20 Primary Entry Delay
0 0.25 seconds 8 4 minutes
1 10 seconds 9 5 minutes
2 20 seconds 10 10 minutes
3 30 seconds (Default) 11 15 minutes
4 45 seconds 12 18 minutes
6 2 minutes 14 21 minutes
7 3 minutes 15 21 minutes
This is the period of time allowed to enter and disarm the panel before an alarm condition is registered.
The entry delay begins after the violation of a primary Entry/Exit zone. During this period, it is permissible
to violate Follower zones without causing an alarm condition provided that an Entry/Exit zone was
violated first. If a Follower zone is violated without a prior Entry/Exit zone violation, it will be treated as an
Instant zone. If an Instant zone is violated during this period, the alarm condition will immediately be
registered. Select the appropriate value for the primary entry delay from the table above.
LOCATION 21 Hardware Reset Switch Enable/Disable
WARNING:
Make certain that the new installer code has been correctly entered before disabling the reset switch.
10 Disable
15 Default Enable
To Next Page
Loading...
Need help?
General
