IDS 805 - Page 29

29
IDS 805 Installer Manual 700-266-02H Issued September 2009
EXAMPLE:
Assuming a phone number consisting of an area code 031, a 4 second pause and a phone number of
705 1373
Location
Value Programmed
48 10 - 1st digit of area code
49
3
- 2nd digit of area code
50 1 - 3rd digit of area code
51 15 - 4 second delay
52
7
- 1st digit of phone number
53 10 - 2nd digit of phone number
54 5 - 3rd digit of phone number
55
1
- 4th digit of phone number
56 3 - 5th digit of phone number
57 7 - 6th digit of phone number
58 3 - 7th digit of phone number
59 0 - terminate number
LOCATIONS 64-79 Secondary Telephone Number
Loc. No.
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
These locations contain the secondary telephone number that may be up to sixteen digits long. The
same procedures apply as for the Primary Telephone Number.
Communicator Reporting Codes (Locations 80-133)
With the exception of Contact ID and Sescoa Superfast, all other communications formats are 4 x 2
reporting formats i.e. a 4-digit account code will be reported with a 2 digit reporting code. It will be noted
that some reporting functions require that both digits of the reporting code be programmed while others
only require a single digit to be programmed. Reporting codes with only one digit will have the second
digit added automatically by the panel. An explanation is provided under each reporting code. It is
however important to note that wherever space is provided for the programming of 2 reporting digits i.e.
Locations 86 and 87 for zone 1 reporting code BOTH DIGITS MUST BE PROGRAMMED.
NOTE:
 To disable any of the reporting codes program a [0] into the locations for both digit 1 and digit 2.
 All reporting codes that require a “0” to be reported must be programmed as a [10] i.e. An “A”
will be reported in the place of the “0” as per the hexadecimal values below.
Numerical
Value
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Hexadecimal
Value
1 2 3 4 5 6 7 8 9 A B C D E F
LOCATIONS 80-81 Duress Reporting Code
This code will be reported if the panel is disarming using the duress code (User 15 is the duress code –
see the User Manual).