IDS 805 User Manual

36
IDS 805 Installer Manual 700-266-02H Issued September 2009
LOCATION 149 Keypad Buzzer Options
Value
Action
0 No beep
1
Beep on trouble
2 Default
Beep on communication
3
Beep on trouble, beep on communication
The keypad can be programmed to beep once to indicate successful communication of data to the base
station, and intermittently (on/off) to provide and audible indication of a trouble condition. The beeping
can be cancelled by pressing [#]. For a list of trouble conditions and how to view them refer to the
section headed "Trouble Conditions" in the User Manual. Enter the appropriate value from the above
table.
LOCATION 150
Hardware Enable Siren/TLM
Value
Telephone Line
Monitoring
Siren Tamper
Monitoring
Box Tamper
Monitoring
0 Default
  
1 
 
2   
3
 

4
 

5   
6 
 
7
  
Enabled
 Disabled
This location allows the permanent enabling/ disabling of telephone line and siren tamper monitoring. For
example, if the telephone line monitoring has been disabled, if the line voltage drops below 9V for more
than 30-60 seconds, it will not be reported to the base station or to the panel as a trouble condition nor
will it be recorded on the event log.
LOCATION 151 Dial Attempts (Default = 4)
Determines the maximum number of dial attempts the panel will make to contact the base station.
NOTE:
Entering [0] into this location will disable the dialler.
LOCATIONS 152-155
Secondary Communicator Account Code
This account code is used if the panel is communicating to two base stations and will be transmitted to
the secondary phone number. See Locations 43 - 46 for information regarding the programming of these
locations.

IDS 805 Specifications

General

Zones	8
Model	IDS 805
Backlight	Yes
Voltage	12V DC
Current	50mA
Display	LED
Operating Temperature	-10°C to +50°C