2019-11-19
21
IDS NXT: Setup IDS NXT rio
The camera powers off briefly and boots in the service firmware.
ids_devicecommand
Use the ids_devicecommand tool from IDS peak to boot the camera in runtime firmware.
Fig. 10: Boot the runtime firmware
1. Open the ids_deviceupdate tool at the command prompt.
2. You can first display all available cameras to identify the serial number:
ids_devicecommand --list-devices
3. You use the serial number to define which camera should boot into runtime firmware:
ids_devicecommand -s 4103616675 --reset-to-runtime
The camera powers off briefly and boots in the service firmware.
To Next Page
Loading...