58 NEO2 Error Code Reference
EE0E User Interface Event
EE11 Communication type not supported, VT-1, burst, etc.
EE12 Secure interface is not functional or is in an intermediate state.
EE13 Data field is not mod 8
EE14 Pad 0x80 not found where expected
EE15 Specified key type is invalid
EE16 Could not retrieve key from the SAM (InitSecureComm)
EE17 Hash code problem
EE18 Could not store the key into the SAM (InstallKey)
EE19 Frame is too large
EE1A Unit powered up in authentication state but POS must resend the InitSecureComm command
EE1B The EEPROM may not be initialized because SecCommInterface does not make sense
EE1C Problem encoding APDU
EE20 Unsupported Index (ILM) SAM Transceiver error - problem communicating with the SAM (Key Mgr)
EE21 Unexpected Sequence Counter in multiple frames for single bitmap (ILM) Length error in data
returned from the SAM (Key Mgr)
EE22 Improper bit map (ILM)
EE23 Request Online Authorization
EE24 ViVOCard3 raw data read successful
EE25 Message index not available (ILM) ViVOcomm activate transaction card type (ViVOcomm)
EE26 Version Information Mismatch (ILM)
EE27 Not sending commands in correct index message index (ILM)
EE28 Time out or next expected message not received (ILM)
EE29 ILM languages not available for viewing (ILM)
EE2A Other language not supported (ILM)
EE50 Auto-Switch OK
EE51 Auto-Switch failed
EE60 Data not exist
EE61 Data Full
EE62 Write Flash Error
EE63 Ok and Have Next Command
EE80 Cannot start Contact EMV transaction
EE81 CTLS/MSR cancelled due to card insertion
EE90 Account DUKPT Key not exist
EE91 Account DUKPT Key KSN exhausted
#80152504-001 IDTech iOS SDK Guide for NEO2
To Next Page
Loading...
