57
Chapter 8
NEO2 Error Code Reference
0000 OK
0001 Incorrect Header Tag
0002 Unknown Command
0003 Unknown Sub-Command
0004 CRC Error in Frame
0005 Incorrect Parameter
0006 Parameter Not Supported
0007 Mal-formatted Data
0008 Timeout
000A Failed / NACK
000B Command not Allowed
000C Sub-Command not Allowed
000D Buffer Overflow (Data Length too large for reader buffer)
000E User Interface Event
0011 Communication type not supported, VT-1, burst, etc.
0012 Secure interface is not functional or is in an intermediate state.
0013 Data field is not mod 8
0014 Pad 0x80 not found where expected
0015 Specified key type is invalid
0016 Could not retrieve key from the SAM (InitSecureComm)
0017 Hash code problem
0018 Could not store the key into the SAM (InstallKey)
0019 Frame is too large
001A Unit powered up in authentication state but POS must resend the InitSecureComm command
001B The EEPROM may not be initialized because SecCommInterface does not make sense
001C Problem encoding APDU
0020 Unsupported Index (ILM) SAM Transceiver error - problem communicating with the SAM (Key Mgr)
0021 Unexpected Sequence Counter in multiple frames for single bitmap (ILM) Length error in data
returned from the SAM (Key Mgr)
0022 Improper bit map (ILM)
0023 Request Online Authorization
0024 ViVOCard3 raw data read successful
0025 Message index not available (ILM) ViVOcomm activate transaction card type (ViVOcomm)
0026 Version Information Mismatch (ILM)
0027 Not sending commands in correct index message index (ILM)
0028 Time out or next expected message not received (ILM)
0029 ILM languages not available for viewing (ILM)
002A Other language not supported (ILM)
0050 Auto-Switch OK
0051 Auto-Switch failed
0060 Data not exist
0061 Data Full
0062 Write Flash Error
0063 Ok and Have Next Command
0090 Account DUKPT Key not exist
0091 Account DUKPT Key KSN exhausted
EE00 OK
EE01 Incorrect Header Tag
EE02 Unknown Command
EE03 Unknown Sub-Command
EE04 CRC Error in Frame
EE05 Incorrect Parameter
EE06 Parameter Not Supported
EE07 Mal-formatted Data
EE08 Timeout
EE0A Failed / NACK
EE0B Command not Allowed
EE0C Sub-Command not Allowed
EE0D Buffer Overflow (Data Length too large for reader buffer)
IDTech iOS SDK Guide for NEO2 #80152802-001
To Next Page
Loading...
