To Next Page

To Previous Page

Instruction Manual

STARTUP, OPERATION AND TEMPERATURE ADJUSTMENT

Operation

•Priortostockingcoolerwithproduct,itshould

be operated empty for half an hour.

Temperature Adjustment

REPAIR AND MAINTENANCE FOR REFRIGERATION DRAWER

* A CERTIFIED TECHNICIAN IS REQUIRED TO REPAIR ALL

REFRIGERATION COMPONENTS FOR WARRANTY PURPOSES.

For convenient repair, the refrigeration components (compressor,

evaporator,condenser,evaporationfan,condensationfanandlter)are

designed using a split system; any component can be easily replaced.

Replacementprocedureisasfollows:

1 Unplug the unit.

2 Removethescrewsfromthefrontgrill,andthenremovethegrill.

3 Unplug all connections and terminals that are in need of repair.

• G-10f/GCG-10f performance testing

position of the thermostat is around 4-6.

•Componentshownattheleft

functionsasasecondarypower

sourceforlowvoltageitemssuchas

signs.

4 Usingascrewdriver,removethe(3)screws

fromtherefrigerationdrawerbaseplate.

5 SlidetheRefrigerationDrawerouttoeasilyaccess

refrigeration components. Remove the component to replace or

repair.

6 Afterrepair,re-installallpartsusingthereverseprocedure.

Lit Door “Logo”

Switch

Operation

• For GCG-10f

coolers only.

Thelightswitch

located at the bottom

left hand side on the rear of the

cabinetistheON/OFFswitchforthe

Lit logo located on the door of cooler.

IDW G-10-F33EB-HC User Manual

Questions and Answers: