IDW G-10-F33EB-HC User Manual

Innovative DisplayWorks
G-10f/GCG-10f
8 Remove door limit from right hinge into corresponding
holes on left hinge.
9Feedthewiringterminalsthroughthehingeandconnect
the terminals.
10Reinstallthetorsionrodintothenew
positionofthedooraxis.
11Settheupperhingeintothetorsionrodatapproximatelya
60°angle.Rotatethehingetotherightcounter-clockwise
aligningtheholesinthebracketwiththeholesontopof
the cabinet.
12 Install the limit to the door. Installing sequence—the
wavewasher—gasket-limit-bolt
13 Check to ensure the door is securely attached and
functioning properly.
14 Attachthefrontgrilltocompletethedoorreversal
process.
DOOR REVERSAL Cont. (For G-10f Coolers Only)
12
         
door sreservedhole,thengetthroughhingeaxie,connect
theterminals.
10.assemblethefrontgrill,completethereversibledoor
exchange.
9.fixtheupperhingeintoleftaxiesleeve,then
anticlockwiserotatethehingetorightpositiontofasten
it.
8.clockwiserotatetheleftaxiesleeve60°.
8.Remove door limit from right hinge into
corresponding holes on left hinge
9.Feed the wiring terminals through the
hinge and connect the terminals.
12.Install the limit to the door.
Installing sequence：the wave
washer—gasket-limit-bolt
6
7
10. Reinstall the torsion rod into the new
position of the door axis.
11. Set the upper hinge into the torsion
rod at approx a 60°angle. Rotate the hinge
to the right counter clockwise aligning the
holes in the bracket with the holes on top
of the cabinet.
wiring is stretching out from the bottom
of the door left
7. Remove the hinge axis from the right
bottom hinge, inert it into the left bottom
hinge.

IDW G-10-F33EB-HC Specifications

General

Brand	IDW
Model	G-10-F33EB-HC
Category	Freezer
Language	English