20V is equal to 100W with a 4 ohm loudspeaker. These levels are very high and can damage many headphones and/or drive most
ampliers (if used as a line-stage) into very hard clipping. Damage to headphones and/or loudspeakers may result from excessively
high volume settings.
Volume Control
To control the volume.
Tip: For loud but normal listening levels, the volume control should be between 10 and 2 o’clock. Adjust the gain upwards if the
volume is unsatisfactory. If one cannot turn up the volume to even 10 o’clock (at the lowest gain setting), please connect the
headphone to the iEMatch embedded 3.5mm connections, which are matched to high-sensitivity headphones such as
in-ear-monitors and other high-sensitivity modern headphones designed to operate from portable devices.
IR Remote Control
Window for IR Remote Control receiver.
Balanced Input
Balanced/XLR x 1.
Unbalanced Inputs 1-3
RCAs x 3.
Balanced Line Output
Balanced/XLR Output.
Unbalanced Line Outputs
RCA Outputs.
10
10.
12.
.
11
13.
14.
15.
To Next Page
Loading...
