What to do if IFM Electronic Accessories has faulty low-flow or high-flow adjustment?
If you experience a faulty low-flow or high-flow adjustment (e.g., the distance between maximum and minimum flow is too small) with your IFM Electronic Accessories, repeat the flow adjustment.
What to do if parameter setting is outside the valid range in IFM Electronic Accessories?
If you face a parameter setting outside the valid range for your IFM Electronic Accessories, check the parameter setting.
General| Brand | IFM Electronic |
|---|---|
| Model | SA 00 Series |
| Category | Accessories |
| Language | English |
Adjusts sensor output and display via a calibration factor for application.
Details sensor placement, immersion depth, and tightening torques.
Step-by-step instructions for navigating and changing parameters.
Sets operating mode (REL, LIQU, GAS) and defines internal pipe diameter.
Configures switching signals for flow limit values for OUT1 and OUT2.
Sets up frequency output based on flow values for OUT1 and OUT2.
Configures the 4-20mA analogue output for flow measurement on OUT2.
Guides on performing high-flow and low-flow adjustments.
Configures limit value switching signals for temperature on OUT2.
Sets up frequency output based on temperature values for OUT2.
Configures the 4-20mA analogue output for temperature on OUT2.
Defines output behaviour (ON/OFF/OU) during fault conditions.
Resets all parameters to their original factory default settings.
To Next Page