Need help?Do you have a question about the IFM PI2798 and is the answer not in the manual?
General| Brand | IFM |
|---|---|
| Model | PI2798 |
| Category | Accessories |
| Language | English |
Describes the analog signal output for 2-wire operation (4-20 mA or 20-4 mA).
Details output options for 3-wire operation, including switching signals and IO-Link.
Outlines the three steps for setting parameters: select, set, and acknowledge.
Sets the switching function for OUT1 (Hno, Hnc, Fno, Fnc).
Performs zero point calibration or automatic offset adjustment.
Configures how outputs behave in case of a fault (ON, OFF, or irrespective).
Sets switch-on and switch-off delays for switching outputs.
Sets the switching logic for outputs (pnp or npn).
Sets damping for switching signals and display.
Sets damping for the analogue signal.
Calibrates the curve of measured values by setting calibration points.
Resets all parameters to their original factory settings.
Sets the simulation value for output states or process values.
Sets the duration for the simulation process in minutes.
Initiates or aborts the simulation process.
Explains self-diagnostic capabilities and error indications.
To Next Page
