6
OPERATING INSTRUCTIONS
IMPORTANT
When the radiator is in use, it should always be kept vertical (handle should be at the top). Putting the
radiator in any other position could be dangerous and cause a potential re hazard.
Using your Radiator for the First Time
• When the radiator is turned on for the rst time, operate at its maximum heat setting for at least
two hours. Ensure you are in a well ventilated area during this time as the heater will give off a “new”
smell. This is completely normal.
• The radiator will make cracking noises when it is rst turned on and when it is turned off and
cooling down.
APPLIANCE OVERVIEW
Indicator light
Thermostat and
on/off control knob
Control panel
Front supportRear support
Assembly method
Figure 2. Figure 3. Figure 4.
Take out the radiator and all the parts from packing carton.
1. Turn the radiator upside down, as shown in Figure 2
2. Insert front supporting foot into the slot on the control panel, as shown in gure 3
3. Clip in the back foot along the slot of the last radiator n, as shown in gure 4
4. Finally, turn the correct way up to stand on its feet.
Figure 1.
To Next Page
Loading...
