Why iGenix IG5005 not working?
Your iGenix Heater might not be working because it is not properly plugged into the mains wall socket. Ensure it is plugged in firmly. It could also be that the heater is not switched on, so make sure to switch it on. Finally, there might be no electricity in the mains wall socket; in this case, check the fuse or breaker.
What to do if iGenix Heater is getting too hot?
If your iGenix Heater is getting too hot, it may be due to inadequate airflow. Make sure there is circulating air in the room. Another cause could be that the heat setting is too high; adjust the heat settings accordingly. Also, check if the vents are blocked and ensure they are clear and free from obstruction.
Why is my iGenix IG5005 Heater getting too hot?
Your iGenix Heater might be overheating due to several reasons: * Inadequate air flow: Ensure there is sufficient circulating air in the room. * Heat setting too high: Adjust the heat settings to a lower level. * Blocked vents: Clear any obstructions from the vents to allow proper airflow.
What to do if my iGenix Heater does not work?
If your iGenix Heater isn't working, consider these potential causes: 1. It might not be properly plugged into the mains wall socket. Ensure it is firmly plugged in. 2. The heater might not be switched on. Make sure the appliance is switched on. 3. There might be no electricity in the mains wall socket. Check the fuse or breaker.
General| Type | Oil Filled Radiator |
|---|---|
| Power | 2000W |
| Thermostat | Adjustable Thermostat |
| Safety Features | Overheat Protection, Tip-Over Switch |
| Weight | 8.5 kg |
| Cool Air Setting | No |
| Heat Settings | 3 heat settings (800W/1200W/2000W) |
To Next Page
