7
Heating
Note: Ensure the water tank is empty – Please refer to Cleaning and Maintenance section on page 7
for details on how to empty the water tank
• Select dial to Heat
• Press the On/Off button and the heat will automatically select low heat and the fan speed will
operate at medium speed
• Press Heat button to select required heat level
- Low = 1000W
- High = 2000W
• Press Speed button to select required fan speed
Note: You can only select Medium or Low Speed when appliance is operating as a Heater
• To turn off the appliance, press the On/Off button on the control panel, the fan will continue to run
for approximately 30-60 seconds without heat to cool down, then switch off the power switch
located at the side of the appliance.
Timer: The timer will switch off the appliance after a desired period of time; it can be set between 30
minutes to 7 hours and 30 minutes by increments of half an hour.
• There are four positions with indicator lights
- 0.5H = Half an hour
- 1H = One Hour
- 2H = Two Hour
- 4H = Four Hour
• Press Timer button to select desired period of time
• The appliance will automatically switch off at the end of the selected period
Note: If the timer button is not used, the appliance will continue to operate until manually switched off.
Ioniser: The Ioniser function removes dust particles and neutralises unpleasant odours
• Press the Ioniser button to turn on this function and the indicator light will illuminate
• Press the Ioniser button again to turn off this function and the indicator light will switch off
To Next Page
Loading...
