en
14
User manual Costa www.igloo.pl
Remarks and indications
• It is essential to properly level the rack, which prevents the loud operation of the device and shall ensure
proper water (condensate) outlet during defrosting.
• In order to ensure proper food storage conditions, it is forbidden to fully complete the shelves. It is neces-
sary to ensure even load of the shelves and do not exceed their maximal load.
• The fi rst fi lling of the cooling space should be performed after its previous cooling to working temperature.
This principle should also be observed after longer pause in exploitation.
• Do not block any ventilation holes, which would hamper the cooled air circulation (Do not place the pro-
ducts directly by the screen!)
• Do not use electric devices inside grocery product storing chamber
4.1. Temperature regulation
“Igloo” and “Carel” thermostat (temperature regulators) service is described in chapter 7 (p. 17 and 18)
The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device
and maintain it within the determined temperature ranges. The producer enters all settings of temperature regu-
lators required for normal functioning of the device. Before primary actuation the user should control and possibly
set the required temperature inside the device on the control panel.
Digital display – displays the current temperature inside the device.
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious
consequences, including the damage of the cooling device!
5. MAINTENANCE
5.1. Cleaning and maintenance
All maintenance services need to be performed after disconnecting the device from power supply!
Protect electric installation against any damage or water spillage
Do not use water stream to clean the device, only a wet cloth
Do not use any sharp objects to remove dirt!
It is recommended to make a break in the exploitation of the device once a month in order to clean its
interior and naturally defrost the evaporator.
Do not use mechanical agents to fasten the defrosting process!
Elements of device can corrode when improper used and maintenance. To avoid that please
follow the rules:
• Do not allow contact of the surface of the device with substances containing chlorine and / or baking
soda in different varieties, which destroy the protective layer and components of the device (also
includes various stainless steel)
To Next Page
Loading...
