en
16
User manual Costa www.igloo.pl
(This concerns the “CAREL” thermostat) Thermostat displays E0 or E1 or L0 or HI or EE or Ed or DF instead
of temperature:
• E0 – temperature sensors inside the chamber are damaged – call authorized service
• E1 – failure of evaporator sensor - call authorized service
• L0 – low temperature alarm (lower than temperature range set within the device – call authorized service
• HI – high temperature alarm – call authorized service
• EE – internal defect of the regulator – call authorized service
• Ed – max. defrosting time exceeded
• DF – defrosting in progress (this is not an alarm signal)
Steam precipitation on glasses of the device is a normal phenomenon in case of high relative air
humidity exceeding 60% and does not require calling the service!
6.2. Service
IGLOO service telephone number: +48 (14) 662 19 56 or +48 605 606 071, e-mail: serwis@igloo.pl
If after checking points described in chapter 6.1 ”Fault identifi cation and repair” the device still does not work pro-
perly, please contact Technical Service of the Igloo company, stating the data from the data plate Fig. 10 (p.16)
• Serial number (NS)
• Production date
• Type (name of the device)
and
• Date when the device was purchased
• Description of the problem
• Your exact address
and telephone number (with the code number)
The above fi gure shows a demonstrative data
plate and the data stated on the plate are
exemplary data, which are not related with
“COSTA” refrigerating racks!
Fig.10 Data plate
To Next Page
