Igloo JSCRP - 5 Maintenance

REFRIGERATION LTD
Pastry Cases | www.igloorefrigeration.com
11
c0
compressor and fan start delay on power-up
1
min
0
100
c1
minimum time between consecutive compressor starts
1
min
0
100
c2
minimum compressor off time
1
min
0
100
c3
minimum compressor on time
0
min
0
100
c4
compressor on time with duty setting
50
min
0
100
cc
continuous cycle duration
2
2
0
15
c6
temperature alarm bypass after continuous cycle
2
h
0
15
d0
type of defrost
0
-
0
4
dI
interval between defrosts
8
h
0
199
dt
end defrost temperature set point
12.0
°C
-50
130
dP
maximum defrost duration
60
min
1
199
d4
defrost when switching the instrument on
0
-
0
1
d5
defrost delay on power-up or when enabled by digital input
0
min
0
199
d6
freeze control temperature display during defrost
1
-
0
1
dd
dripping time
2
min
0
15
d8
alarm bypass time after defrost
1
h
0
15
d9
defrost priority over compressor protectors
0
-
0
1
d/
defrost probe reading (2)
-
°C
-
-
dC
time base
0
-
0
1
A0
alarm and fan temperature differential
2.0
°C
-20
+20
AL
absolute/relative temperature for low temperature alarm
0.0
°C
-50
+99
AH
absolute/relative temperature for high temperature alarm
0.0
°C
-50
+99
Ad
temperature alarm delay
0
min
0
199
A4
3rd input configuration
0
-
0
11
A7
digital input alarm delay
0
min
0
199
A8
enable alarm “Ed” (end defrost by timeout)
0
-
0
1
AC
set point dirty condenser alarm
60
°C
-50
250
AE
dirty condenser alarm differential temperature
3.0
°C
0.1
20
Acd
dirty condenser alarm delay
0
min
0
250
H0
serial address
0
-
0
207
H1
AUX output configuration
0
-
0
2
H2
enable keypad
1
-
0
2
H4
disable buzzer
0
0
1
H5
ID code (read-only)
1
-
1
+199
EZY
restore the Default settings
2
0
0
1
5. MAINTENANCE
 Before you start Maintenance on the unit, Power it OFF.
 Do not use steel wool, abrasive cleaners, bleach or cleaners containing chlorine or sodium to clean the unit.
 Do not use a pressure washer or water-jet to clean the unit.
 The unit should be cleaned right after unpacking and before turning it on.
 The unit should be cleaned with warm water and a mild soap.
 Make sure to cover the fan motor to prevent moisture damage.
 Door gaskets, shelves and supports should be cleaned on a regular basis.
 Fan blades and guards should be cleaned with a soft cloth.