Igloo MAX - Service and Troubleshooting; Fault Identification and Repair; Condenser Maintenance Warning

en
14
User manual MAX www.igloo.pl
Fig.4 Cleaning the condenser
The producer shall not be held responsible for damages of the condenser aggregate resul-
ting from non- observance of condenser cleanliness!
It is essential to keep the condenser of the device clean. Dirt may hinder the heat exchange, causing mainly increase in
electric energy consumption and may cause damage of aggregate compressor.
In order to clean the condenser it is necessary to unscrew the xing sheet metal screws and pull the wind brace out.
Clean condenser lamellas with help of soft brush or paint brush. If the condenser is extremely dirty (blocked lamellas) it is
indicated to use vacuum cleaner or compressed nitrogen to suck / blow the dirt from be- tween lamellas.
Rys. 5. Changing the uorescent
lamp
1 – Fluorescent lamp handle
2 – Fluorescent lamp
3 – Casing of the uorescent lamp
During maintenance services it is necessary to pay attention not to damage the data place of the device
Fig.11 (p.25), which contains signicant information for servicing organs and waste removal companies.
6.SERVICE
6.1.Fault identication and repair
In case of any difculties during actuation of the device or during its exploitation, please return to these chapters in
this manual, which explain the performed operation. This aims to ensure that the device is properly operated.
If you still experience difculties, the following hints will help you solve the problem.
The device is not working... – Make sure that:
• The device is connected to the supply network
Voltage and frequency in the network are compliant with those recommended by the producer 230V/50Hz
• The main switch is on
• Thermostat is on (This concerns the Igloo thermostat – If only two spots are visible on the display – turn on
the thermostat)