In the case of environmental conditions exceeding normal levels in accordance with refrigerator
class three (relative humidity above 60%), the phenomenon of water pouring from the system with
automatic condensate evaporation (evaporators) may occur. This is not a malfunction and does
not require a service call.
Noises made by the operating device are a normal phenomenon. The devices are equipped with ventila-
tors, engines and compressors, which turn on and off automatically. Each compressor makes certain
noises when operating. These sounds are made by the aggregate engine and by cooling agent
owing through the circuit. This phenomenon constitutes a technical feature of cooling devices
and it does not signify their faulty work.
Steam precipitation on glasses of the device is a normal phenomenon in case of high relative air
humidity exceeding 60% and does not require calling the service!
6.2. SERVICE
If after checking points described in chapter 6.1 „Fault identication and repair” the device still does not work properly, please
contact Technical Service of the Igloo company, stating the data from the data plate Fig.10 (p.18):
• Serial number (NS)
• Production date
• Type (name of the device)
and
• Date when the device was purchased
• Description of the problem
• Your exact address and telephone number (with the code number)
Data plate is placed at the back of the device, in the right upper cor-
ner below the top Fig.1/18 (p.12)
The above gure shows a demonstrative data plate
and the data stated on the plate are exemplary data,
which are not related with “SAMOS” device!
Fig.10 Data plate
To Next Page
Loading...
