IHI 55N3 - Maintenance; Maintenance Interval Schedule

3 – 1
ᵑ
MAINTENANCE
MAINTENANCE INTERVALS
When Required
Track
Track
Fuses
Fusible Link
Battery
Bucket
Daily Check (8 Service hours)
Engine Oil
Engine Coolant
Hydraulic Oil Tank
Fuel Tank
Air Cleaner
Water Sedimenter
Every 50 Service Hours (First perform previous service hour items)
Fuel Tank
Attachment Pins
Swing Bearing
Engine Oil
Hydraulic System
Every 250 Service Hours (First perform previous service hour items)
Engine Oil
Air Cleaner
Fan Belt
Coolant
Every 500 Service Hours (First perform previous service hour items)
Tighten Bolts
Return Filter
Fuel Filter
Travel Drive
Every 1000 Service Hours (First perform previous service hour items)
Travel Drive
Hydraulic Tank
Every 2 years Service Hours
Coolant
* Interval given applies only to initial period of use (Break-in).
Check and Adjust Tension
Check Rubber Shoes
Replace
Replace
Clean and Check Electrolyte Level
Change Bucket
Check Oil Level
Check Coolant Level
Check Hydraulic Oil Level
Check Fuel Level
Check Servise Signal
Check Level and Drain Water
Drain Water and Sediment
Lubricate Fitting with Grease
Lubricate Fitting with Grease
Change Oil and Filter *
Change Return Filter *
Change Oil and Filter
Clean or Change Filter Elements
Inspect and Adjust
Change Coolant (When not used L.L.C)
Retightening Bolt
Change Return Filter
Change Filter Elements
Check Oil Level
Change Gear Case Oil
Change Hydraulic Oil and Clean Strainer
Change Coolant (When used L.L.C)
3 – 4
3 – 5
3 – 6
3 – 6
3 – 7
3 – 8
3 – 10
3 – 10
3 – 11
3 – 11
3 – 11
3 – 12
3 – 14
3 – 2
3 – 2
3 – 15
3 – 21
3 – 15
3 – 16
3 – 19
3 – 26
3 – 20
3 – 21
3 – 22
3 – 22
3 – 23
3 – 24
3 – 26
Check Point Item Page