Your Autovac comes equipped with a Powermop Scrub mopping attachment that connects to the 2-in-1 Dustbin/Water Tank. Follow the steps below to initiate
wet mopping with your Autovac.
Place the mop pad onto the mop attachment and secure it to the Velcro
strips. Slip corners of the mop pad over the plastic tabs at the rear of
the mop attachment.
1
Slide mop attachment onto dustbin as shown in gure below until you
hear a click con rming that it is locked in place.
2
strips. Slip corners of the mop pad over the plastic tabs at the rear of
hear a click con rming that it is locked in place.
15
USING POWERMOP SCRUB
To Next Page
Loading...
