English
20
6.2 ARC calibration
When one of the pushbuttons is assigned to the ARC calibration, the remote control will assist you in the
process both if the measurement is launched from the speaker itself with CAL/PRESET button or if it is launched
by the control software.
When the system is in the ARC calibration process, the four buttons on the remote control are actually linked to
the four measurement positions.
Each step of the measurement can be triggered by pressing the corresponding button on the remote control.
Each button’s LED will slowly blink during the phases when the microphone has to be placed at the requested
position, and will fast blink during the measurement of the test signal.
Once the calibration process has completed successfully all four buttons on the remote will flash for 3 seconds.
6.3 Other functionalities
From the control software it is possible to assign other functionalities to the remote control, such as:
- speakers MUTE;
- speakers DIM;
- ARC on/off;
7. Listening position
When you use iLoud Precision 6 for stereo applications, the optimum listening position should be located in
the middle of an imaginary triangle. This means that your listening point (sweet spot) will be located at the top
of an equilateral triangle and the two loudspeakers should be placed at the other two corners of this triangle.
Furthermore, a symmetrical positioning is also important: this applies to the distance between speakers as
well as to the walls, ceiling and floor. In order to have a symmetrical stereo image it is also important to have
symmetrical reflections: we recommend keeping a distance of at least 20 cm (8 inches) from the walls, in order
to avoid low frequency emphasis.
To Next Page
Loading...
