English
11
Setting input level
You can adjust the input level of your instrument via the dedicated thumbwheel. To increase the input
level rotate the thumbwheel control toward the TRRS captive cable. To decrease the input level rotate the
thumbwheel control toward the 1/4” instrument input jack.
For the best sound, adjust the input level so that it’s as high as possible while still retaining a “clean” sound
that’s not distorted or overloaded.
• If the input level is set too low you will have noise in your signal.
• If the input level is set too high you will have a distorted signal.
To Next Page
Loading...
