IKA RCT basic - Assembling the Stand; Correct Use; Unpacking

17
Unpacking
• Unpacking
- Please unpack the device carefully
- In the case of any damage a detailed report must be sent
immediately (post, rail or forwarder)
• Contents of package
- Heating magnetic stirrer
- Mains cable
- Operating instructions
- Screwdriver
- Protection cover
- Temperature sensor PT 1000
• Use
- For mixing and / or heating liquids
• Range of use
- Laboratories - Schools
- Pharmacies - Universities
This device is suitable for use in all areas, except industrial areas.
The safety of the user cannot be guaranteed if the appliance is
operated with accessories that are not supplied or recommended
by the manufacturer or if the appliance is operated improperly
contrary to the manufacturer’s specifications or if the appliance or
the printed circuit board are modified by third parties.
Correct use
Assembling the stand
Note: When using bath attachments with
a diameter over 180 mm, please use sup-
port rod in conjunction with an extensi-
on. (See “Accessories”)
FRemove screw plugs (M)
FRemove the protective cap from the support rod
FPut the washer between housing and nut
FScrew the support rod onto the device
by hand until the end stop is reached
FUse an A/f 17 spanner to tighten the
M10 nut
FAccessories should be attached using
cross sleeves
Risk of tipping!
Make sure that the center of mass of the
attached device does not protrude over
the safe area indicated with a dotted
rectangle.
safe area