The space between the cabinets must be 24“
(61.0cm)wide and free of obstructions.
When installing the microwave oven beneath smooth,
flat cabinets, be careful to follow the instructions on
the top cabinet template for power cord clearance.
As a guide to installation, see page 22 for Mounting
Template Information.
outside, see Hood Exhaust Section for exhaust duct
preparation
Exhaust Adapter
Shelf (For some
models)
Glass Tray
Filters and Turntable
Ring below glass tray
Then carefully roll the oven and carton over onto the
top side. The oven should be resting in the Styro
foam.
Mounting Space
Small Hardware Bag
EN
A. REMOVING THE MICROWAVE OVEN FROM
THE CARTON/ REMOVING THE MOUNTING
PLATE
1. Remove the assembly instructions, advice & instruc-
tion tray,exhaust adapter,turntable ring,shelf,filters,-
glass and the small hardware bag. Do not remove the
Styrofoam protecting the front of the oven.
1
PLACEMENT OF THE MOUNTING
PLATE
Bottom Edge of
Cabinet Needs to
be
"3 0 " ( 76.2cm)
or More from the
Cooking Surface
13
“
Maximum (33 cm)
30
“
24“
(61.0cm)
(76.2 cm)
cm)
min.
Backsplash
66 (167.6 cm)
or More
from
the Floor to the
Top of the
Microwave
If the cabinet depth including the cabinet doors is
more than 13" then the unit must be spaced out from
wall using adequate materials supporting 150 Ibs to
allow proper top vent air exhaust/intake.
16
1
2
(41.9 cm)
2“ (5.1
To Next Page
Loading...
